Embroidery Seat Stand 190-4

The 190-4 seat embroidery stand allows easy embroidering using both hands. It can be used as a table-top stand but is ideally designed to be a seat stand by sitting on the lower base tucked under your legs allowing comfort and creativity at the same time!

The stand has 3 adjustable joints plus the final hoop holding knuckle join that will pivot to any angle so that you can find the optimum height, distance and angle depending on your hoop size for maximum comfort whilst creating your next master piece. 

The stand will hold any size hoop diameter ~ Typically 100mm to 310mm (4" to 12") and hoops up to and including 16mm deep it will fully extend out to 50cm (20"). The hoop can either be clamped as in the picture (top to bottom) or clamped from the inside to the outside with the screw tightening down on the outer side of the hoop. The stand is also good for holding tapestry frames up to 75cm (30").